PTX3 polyclonal antibody (biotin conjugate)

Manuals And Inserts

• Datasheet

Specific Protocol

Sandwich ELISA for PTX3
- 96 well-ELISA plates (Nunc MaxiSorp 446612) were coated with 100µl of MAb to PTX3 (human) (MNB4) (Prod. No. ALX-804-464), 1μg/ml in 100µl coating buffer (15mM carbonate buffer pH 9.6) and incubated overnight at 4°C.
- After incubation, the plates were washed three times with 300µl/well of washing buffer (PBS + 0.05% Tween 20), and then 300µl of 5% dry milk in washing buffer were added to block non-specific binding.
- The plates were incubated for 2 hours at room temperature and then washed three times with washing buffer.
- 50µl (in duplicate) recombinant human PTX3 standard (Prod. No. ALX-201-124) (75pg/ml to 2.4ng/ml ), cell supernatants or biological fluids diluted in PBS without Ca and Mg + 2% BSA were added and then incubated for 2 hours at 37°C.
- The plates were washed five times with washing buffer, and then 100µl of PAb to PTX3 (human) (Biotin) (Prod. No. ALX-210-365B) 50ng/ml in washing buffer were added in each well.
- The plates were incubated for 1 hour at 37°C and then washed five times with 300µl of washing buffer.
- 100 µl/well streptavidin-horseradish peroxidase diluted 1:4’000 were added and the plates incubated for 1 hour at room temperature.
- After incubation the plates were washed 5 times with washing buffer and 100µl of TMB substrate solution was added to each well. After incubation for 10 min. at room-temperature, 50μl of stop-solution (1M H₂SO₄) was added. Subsequently, absorbance was read within 30min at 450nm.

Note: Do not use heparin plasma or serum samples with this assay. EDTA samples are recommended. The detection value in serum is generally less than in plasma samples.

Certificate of Analysis

Please enter the lot number as featured on the product label

Lot No. :

SDS

Enzo Life Science provides GHS Compliant SDS

• English (EU) SDS

If your language is not available please fill out the SDS request form